Difference between revisions of "Upgrade from Pulse to IC-EDGE"
From Zenitel Wiki
(→Prerequisites) |
|||
| Line 13: | Line 13: | ||
== Prerequisites == | == Prerequisites == | ||
| − | * | + | * All devices in the system must be upgraded |
* In an IC-EDGE System, [[:Category:Stations#INCA_stations|INCA stations]] cannot be used as the Edge Controller. | * In an IC-EDGE System, [[:Category:Stations#INCA_stations|INCA stations]] cannot be used as the Edge Controller. | ||
* TCIV video intercoms should not be used as the Edge Controller for systems exceeding 4 devices. | * TCIV video intercoms should not be used as the Edge Controller for systems exceeding 4 devices. | ||
Revision as of 13:27, 11 September 2019
|
This article is under construction! |
This article describes how to upgrade from a Pulse system to an IC-EDGE System.
Contents
Definitions
Pulse System:
- In a Pulse system the Turbine devices are running firmware 3.x or 4.x.
- In a Pulse system the INCA devices are running firmware 2.9 or earlier.
IC-EDGE System:
- In an IC-EDGE system the Turbine devices are running firmware 5.x.
- In an IC-EDGE system the INCA devices are running firmware 2.10 or newer.
Prerequisites
- All devices in the system must be upgraded
- In an IC-EDGE System, INCA stations cannot be used as the Edge Controller.
- TCIV video intercoms should not be used as the Edge Controller for systems exceeding 4 devices.
- VS-IMT can be used for station discovery and upgrade, but should not be used to configure Edge.
Licenses
Pulse licenses will be honored in an IC-EGDE System. This means that when upgrading a Pulse Server to version 5.x, licenses will still be valid.
More information regarding licensing in Edge can be found here.
Select Edge Controller
The Edge Controller must be a Turbine device. If the current Pulse Server is an Inca station, you must select a different device (Turbine) as the Edge Controller.
Upgrade the Stations
In an IC-EDGE System all station must be upgraded to Edge. You cannot mix Edge and Pulse devices.
Make sure all Turbine station runs 5.0.3.0 or newer.
Inca stations must run 02.10.3.0 or newer.
Software can be found here.
Upgrade procedure using VS-IMT can be found here.
Manual upgrade procedure can be found here.
Edge Configuration
Detailed information on how to configure Edge can be found here.