Difference between revisions of "Anti-nuisance control (Event Handler)"
From Zenitel Wiki
| Line 29: | Line 29: | ||
| || [[PROGRAM|$PROG L%2.dir LV]] | | || [[PROGRAM|$PROG L%2.dir LV]] | ||
|- | |- | ||
| − | |||
|} | |} | ||
| − | |||
--------------- | --------------- | ||
| Line 49: | Line 47: | ||
|- | |- | ||
|} | |} | ||
| + | |||
------------------ | ------------------ | ||
[[Category:Applications]] | [[Category:Applications]] | ||
Revision as of 14:18, 18 November 2008
This article describes how a master station can disable substations from making calls for a periode of time.
Solution
In the programming example below the master station dials 9535 + substation directory number to disable calls from that substation for 15 minutes.
Directory number 9535 is by default a two-step event trigger, feature 95/0. When 9535 + Substation is dialled, an event type 25 is triggered and the action string $SSC L%2.dir U2 moves the substation to COS 2. COS 2 is by default empty, which will prevent calls to be initiated. The command $DISCON_ST L%1.dir U2 will disconnect the master station with a success tone after having entered the substation number. A 15 minute timer is started by the command $ST L%2.dir W9000 L9999. When the timer expires it will trigger event type 21, and the command $SSC L%1.dir U1 will move the station back to COS 1, and calls can again be made.
Event 1 - Move the substation to COS 2, start a timer, and disconnect the master station.
| Event Owner: | The Master Station |
| Event type: | 25 – Event trigger with parameter |
| Subevent: | 0 |
| When change to: | ON |
| When related to: | All |
| Action: | $SSC L%2.dir U2 |
| $ST L%2.dir W9000 L9999 | |
| $DISCON_ST L%1.dir U2 | |
| $PROG L%2.dir LV |
Event 2 - Move the substation back to COS 1.
| Event Owner: | Stations w/UDP, Id: 8 (All stations) |
| Event type: | 21 – Event timer |
| When change to: | ON |
| When related to: | Directory number, Id: 9999 |
| Action: | $SSC L%1.dir U1 |