Search results

Create the page "AS" on this wiki! See also the search results found.

• Schneider Security Expert - ICX-AlphaCom Integration
  ...an external IP camera, create a camera for the intercom in Security Expert as follows: ...tercom’s number is 300 and its IP address is 192.168.1.125, define the URI as 300@192.168.1.125.
  7 KB (1,008 words) - 15:14, 16 March 2023
• 1-2a. Analogue Stations – Dual Display (solution)
  *Use the section on the right and change the configuration as follows:
  2 KB (255 words) - 10:03, 30 June 2022
• AMC-IP - AlphaCom Processor Board (Black)
  ...he STIC card by inserting it into the SIM Card socket of the AMC-IP board, as indicated in the picture to the right. ...st be inserted from the rear side of the cabinet in the same card position as the AMC-IP card. After insertion, the filterboard must be fixed by the two
  4 KB (599 words) - 01:35, 25 June 2021
• Stentofon Simple Link Layer
  ...nt link layer can be used for inter-node links, links to local devices and as an operator interface. (Multiple devices can be connected to a single link ...eral devices are set up on the port, the lowest device number will be used as default device number in commands where device number is not stated explici
  17 KB (2,713 words) - 14:54, 7 September 2017
• 1-4g. Main Features - Alarm Message Distribution (solution)
  ...ad of using the standard alarm message, a new customized message available as wav file should be used:''
  2 KB (255 words) - 10:06, 30 June 2022
• Weather and Vandal Resistant IP Substation - 1008042100
  This station is fully supported as from AlphaCom version 10.20
  2 KB (204 words) - 09:52, 16 August 2022
• PrisCom Station Connections
  An 8-pin IDC connector carrying the general purpose outputs L1 – L6 as 3V/1mA signals which may be used for connection to the STENTOFON [[MRBD]] r ...in series with the station tamper switch. The pins are shorted by a jumper as default. External NC tamper switches may be connected to this terminal by u
  8 KB (1,425 words) - 16:05, 29 February 2024
• Advancis WinGuard
  ...m > Serial Ports]], and select one of the available ACDP links and program as follows: ...face of the ICX-AlphaCom or AlphaCom XE, make certain that the TCP/IP port as selected above is defined and enabled in the [[AlphaWeb#Filters|Filter-page
  21 KB (3,279 words) - 14:45, 30 June 2023
• ELSII-10H
  This station is fully supported as from AlphaCom version 11.2.3.7
  2 KB (204 words) - 12:51, 23 June 2023
• IP Desk Master -V2
  This station is fully supported as from ICX-AlphaCom version 11.2.3.7
  2 KB (207 words) - 13:37, 29 January 2024
• AUDIO PATH SETUP
  ...hange features. To speed up things, the feature setup message is included as “payload” of this message. ...olspan="3"|If call was set up by [[CALL SETUP]] message: Call mode options as specified in a CALL_SETUP message. Optional, rest is omitted if zero <br>
  5 KB (670 words) - 16:07, 6 July 2022
• Milestone External Generic Event
  ...l Generic Event can only be implemented in an ICX-Alphacom Intercom system as it requires that the controller can send text strings via a TCP/IP connecti ...firewall. It is assumed that the ICX-AlphaCom is able to access Milestone as this is required for the plugin to work.<br>
  6 KB (885 words) - 08:44, 16 August 2022
• Tracing AlphaCom data communication
  As from AMC version 11.5.3.1B it is possible to trace various data protocols. ...on''' -> '''Filters''', select '''Add Filters''' and add the same TCP port as defined in the configuration file above. Remember to '''Enable''' the port,
  4 KB (569 words) - 14:16, 8 October 2019
• ELSIR-10C
  This station is fully supported as from AlphaCom version 11.2.3.7
  2 KB (206 words) - 12:51, 23 June 2023
• Elevator alarm to external phone with voice identifcation
  ...rnal telephone, and the location of the alarm is presented to the operator as a spoken message. ...is suitable not only for elevators, but also for other applications, such as:
  15 KB (2,374 words) - 12:09, 24 February 2023
• ITSV-4/5 as Paging Station for PAVA
  The IP-LCM will be set up as the IC-Edge Controller and in the "Directory" menu given number 100, see [[ After the settings are saved and applied you should see all the accounts as registered on the status page
  14 KB (2,142 words) - 15:54, 26 October 2023
• Call Pickup (Event Handler)
  ...tion by dialing 9535 + number of the ringing station. 9535 must be defined as [[Event Trigger with parameter (Event Type)|Event Trigger with parameter]],
  2 KB (250 words) - 13:48, 14 December 2023
• IP Desk Master -V2-P
  This station is fully supported as from ICX-AlphaCom version 11.2.3.7
  2 KB (209 words) - 13:37, 29 January 2024
• Redundant Servers (AlphaCom XE)
  ...nfiguration Master):''' The server in a HA pair that has the configuration as programmed from AlphaPro. This role is defined via the license. The role is Two servers are set up as a redundant HA pair, sharing the same configuration, including node number.
  16 KB (2,500 words) - 17:08, 28 June 2022
• ENA2060 Amplifier - Mounting and Installation
  ...CN) for exchanging data packets with the SIP server and other systems such as Network Monitoring System (NMS). <br> The status indicators display the status of important parameters such as power supply and faults.
  7 KB (1,069 words) - 12:59, 28 June 2024

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)