Anti-nuisance control (Event Handler)

This article describes how a master station can disable substations from making calls for a periode of time.

Solution

In the programming example below the master station dials 9535 + substation directory number to disable calls from that substation for 15 minutes.

Directory number 9535 is by default a two-step event trigger, feature 95/0. When 9535 + Substation is dialled, an event type 25 is triggered and the action string $SSC L%2.dir U2 moves the substation to COS 2. COS 2 is by default empty, which will prevent calls to be initiated. The command $DISCON_ST L%1.dir U2 will disconnect the master station with a success tone after having entered the substation number. A 15 minute timer is started by the command $ST L%2.dir W9000 L9999. When the timer expires it will trigger event type 21, and the command $SSC L%1.dir U1 will move the station back to COS 1, and calls can again be made.

---

Event 1 - Move the substation to COS 2, start a timer, and disconnect the master station.

Event Owner:	The Master Station
Event type:	25 – Event trigger with parameter
Subevent:	0
When change to:	ON
When related to:	All
Action:	$SSC L%2.dir U2
	$ST L%2.dir W9000 L9999
	$DISCON_ST L%1.dir U2
	$PROG L%2.dir LV

---

Event 2 - Move the substation back to COS 1.

Event Owner:	Stations w/UDP, Id: 8 (All stations)
Event type:	21 – Event timer
When change to:	ON
When related to:	Directory number, Id: 9999
Action:	$SSC L%1.dir U1

---