Search results

This article shows possible solutions for redundancy with the ICX-AlphaCom server. ==ICX-AlphaCom redundancy==

AlphaCom is a powerful and flexible communication exchange, designed to provide crit Here you can find useful links about AlphaCom.

[[File:Monitoring AlphaNet 1.PNG|left|thumb|500px|Example 1: Send AlphaNet status to the [[Sy [[File:AlphaNet monitoring.PNG|left|thumb|500px|Example 2: Send a text message to station 1 when an Al

...ATLB-12 line board is used for connection of 2-wire DTMF telephones to the AlphaCom server. * In AlphaCom XE20/XE26 there are several options:

| [[Stentofon.AlphaCom.AlphaNet.dll]] | Library for Handling AlphaNet communication with AlphaCom node(s).

[[File:Monitoring Multimodule 1.PNG|left|thumb|500px|Example 1: Send Module status to the [[S [[Category: AlphaCom Monitoring]]

[[File:Monitoring Pocket Paging 1.PNG|left|thumb|500px|Example 1: Send communication status c [[File:Monitoring Pocket Paging 2.PNG|left|thumb|500px|Example 2: Send communication status c

...s considered an error, and the following message will be sent to [[Syslog (AlphaCom)|syslog]]: ...dication that some external device is stuck in a state transmitting to ICX-AlphaCom, and that port can therefore not be used.

{{AI}} The ENA Amplifier provides extensive monitoring capabilities. ..._mode#Advanced_Config|Amplifier Settings > Advanced Config > Power Source Monitoring]] section

...from selected stations using [[Simplex Conference]] in an ICX-AlphaCom or AlphaCom XE system. The microphone on the monitored station will be activated withou * Start monitoring: Dial 9535 + station number (these numbers can be configured on preconfigur

...the Ethernet link is lost the call will hang until reset is initiated from AlphaCom side. <br /> To avoid this issue a monitoring of received RTP audio is added for AMCD 1043x0521.

SIP nodes in AlphaCom E exchanges are made by creating nodes of the type 'SIP Node'. The SIP node * Select the AlphaCom node number which the SIP Registrar should be related to (normally node 1)

...n, i.e. digit dialing, M-key, handset, C-key (LWT, ITS, CRMIII/CRMIV, MLH) Monitoring of events related to this station (dialing to display, conversation partner * Monitoring of events related to many stations in the exchange (busy, program, line err

...evice allows for the connection of 1 PSTN style telephone to ICX-AlphaCom, AlphaCom or IC-Edge platforms. ...X-AlphaCom or AlphaCom, you require 1 SIP Station License (ICX:1002600700, AlphaCom:1009643001)<br>

...evice allows for the connection of 2 PSTN style telephone to ICX-AlphaCom, AlphaCom or IC-Edge platforms. ...AlphaCom, you require 1 SIP Station License per FXS port (ICX:1002600700, AlphaCom:1009643001)<br>

...in the [[ICX-500 Gateway|ICX-500]] or in the [[:Category:AlphaCom Servers|AlphaCom Servers]] has an unique [http://en.wikipedia.org/wiki/MAC_address MAC addre ...ation, and in the server web interface, [[ICX_Web#Node_Information|System Monitoring > Node information]] and in [[ICX_Web#Licensing|System Configuration > Lice

|'''When change to ON''': || A station's line monitoring has found a problem or if the whole ASLT board becomes faulty |'''When change to OFF''': || A station's line monitoring has found the station OK

...evice allows for the connection of 8 PSTN style telephone to ICX-AlphaCom, AlphaCom or IC-Edge platforms. ...AlphaCom, you require 1 SIP Station License per FXS port (ICX:1002600700, AlphaCom:1009643001)<br>

...Amplifier''' is a 2 x 400 watt IP based amplifier that can register to the AlphaCom server over an IP network. ...Interface|amplifier display]] and fault relay, as well as reported to the AlphaCom server which can raise an event or forward the reports to syslog, SNMP and

...ight get "(500) Internal Server Error" when trying to communicate with the AlphaCom XE. The issue is rectified by configuring the [[Redundant_Servers_-_ICX-AlphaCom#AlphaPro_settings|AlphaPro to communicate with the local IP address of the