Difference between revisions of "Vandal Resistant intercom - VR3G-1"
From Zenitel Wiki
(→Getting started) |
|||
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{AEIS}}[[file:VR3G-1 Front.png|thumb|200px|VR3G-1 (1008021010)]] | {{AEIS}}[[file:VR3G-1 Front.png|thumb|200px|VR3G-1 (1008021010)]] | ||
| − | + | ||
*3mm (11 gauge) Stainless Steel | *3mm (11 gauge) Stainless Steel | ||
*Stainless steel call button | *Stainless steel call button | ||
| − | * | + | *Vandal Resistant Design with IK10 |
| + | *IP66 - Dirt, dust and water resistant | ||
*Tamper switch | *Tamper switch | ||
*Anti-ligature design | *Anti-ligature design | ||
| + | *For mounting in [[Backbox_3_Gang_-_1008098300|3 gang backbox]]. | ||
==Getting started== | ==Getting started== | ||
| Line 30: | Line 32: | ||
*[[:Category:IMX28 Release notes|Software Release Notes]] | *[[:Category:IMX28 Release notes|Software Release Notes]] | ||
| − | ==Connectors, | + | ==Connectors, Mounting and Dimensions== |
| − | + | *[[VR3G-1 and VR3G-1P Board Connectors|Board Connections]] | |
| − | *[[ | + | *[[VR3G-1(P) Mounting and Dimensions|Mounting and Dimensions]] |
| − | |||
| − | *[[VR3G-1 Dimensions|Dimensions]] | ||
==Accessories== | ==Accessories== | ||
Latest revision as of 15:47, 8 September 2023
- 3mm (11 gauge) Stainless Steel
- Stainless steel call button
- Vandal Resistant Design with IK10
- IP66 - Dirt, dust and water resistant
- Tamper switch
- Anti-ligature design
- For mounting in 3 gang backbox.
Contents
Getting started
Configuration
The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
General configuration:
Station specific configuration:
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors, Mounting and Dimensions
Accessories
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.7