Difference between revisions of "Vandal Resistant intercom - VR3G-1P"
From Zenitel Wiki
(→Getting started) |
(→Connectors and Dimensions) |
||
| Line 32: | Line 32: | ||
*[[:Category:IMX28 Release notes|Software Release Notes]] | *[[:Category:IMX28 Release notes|Software Release Notes]] | ||
| − | ==Connectors and Dimensions== | + | ==Connectors, Mounting and Dimensions== |
*[[VR3G-1 and VR3G-1P Board Connectors|Board Connections]] | *[[VR3G-1 and VR3G-1P Board Connectors|Board Connections]] | ||
| − | *[[VR3G- | + | *[[VR3G-1(P) Mounting and Dimensions|Mounting and Dimensions]] |
==Accessories== | ==Accessories== | ||
Revision as of 14:39, 8 September 2023
Vandal Resistant intercom station for mounting in 3 gang backbox
- 3mm (11 gauge) Stainless Steel
- Piezo self testing call button
- Vandal Resistant Design with IK10
- IP66 - Dirt, dust and water resistant
- Tamper switch
- Anti-ligature design
Contents
Getting started
Configuration
The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
General configuration:
Station specific configuration:
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors, Mounting and Dimensions
Accessories
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.7