Search results

Create the page "AS" on this wiki! See also the search results found.

Voice Recording Board (VRB3)
...analog stations connected to AlphaCom [[ASLT]] ports and to present these as transformer coupled, 600 Ohm, nom. 0dBm outputs for recording by (typically ...k connector 13mm pins but which are free at the distant end for connection as required.

2 KB (267 words) - 14:07, 14 June 2018
AUDIO LINK RELEASE
|align=center|3||PAYLOAD||colspan="3"|End-to-end message as received. (See message: [[AUDIO_PATH_SETUP]])

757 bytes (98 words) - 14:20, 6 July 2022
1-3b. IP Stations – Substations (solution)
*Use the section on the right and change the configuration as follows: ...', select physical port 39. Then press the button '''DAK''', and configure as follows:

2 KB (336 words) - 10:04, 30 June 2022
Recorder 2.0 not starting
...ection of the dialog, select '''db_owner''' and leave all other selections as they were

779 bytes (114 words) - 10:25, 15 February 2024
VCP MEET REQ
...an="5"|[[AlphaNet]]: Request answer to global group call <br />REFERENCE: As provided in payload of [[AUDIO_M_PATH_SETUP]]. [[AlphaCom]] uses this field

825 bytes (110 words) - 16:12, 6 July 2022
Configuration of ECP-AA1 station - ICX/AlphaCom mode
* Ensure that the IP address of your PC is in the same range as that of the station IP ...HCP''' or '''Static IP'''. In the latter case, fill in the network details as required.

4 KB (592 words) - 12:38, 9 June 2022
X-Lite softphone
...tory number of the SIP phone. This number must also be defined in AlphaCom as a [[SIP_phone_as_station#AlphaCom_Configuration|SIP Station]]. See [[SIP phone as station]]

4 KB (669 words) - 10:12, 16 August 2022
ENA2060 Amplifier - Speaker Line Monitoring
...ier has the option to monitor each speaker line to detect line faults such as '''Open''', '''Shorted''' or '''Ground Fault'''. <br> The calibration values are used as a reference and are compared with later speaker line measurements for any s

4 KB (535 words) - 01:59, 6 November 2020
AUDIO PATH DELAY
|align=center|-||(Reference field)||colspan="3"|As provided in [[AUDIO_M_PATH_SETUP]]

748 bytes (102 words) - 15:39, 3 October 2019
ST STATE
7: 0 = Tone test OK, 1 = Failed. (11.1.3.2) <br>25-32 = UDP groups as bitmap. ...center|9||[[UINT2]]||colspan="3"|(0 if no conn active)Connection reference as given in [[CONN_STATUS_BC]]

4 KB (525 words) - 13:08, 11 October 2021
Account Settings (SIP)
*'''Backup Domain 2 (SIP)''': This is the tertiary SIP domain used as backup in case the primary and secondary domains fail. This can be either a ** '''Cisco''': Cisco registration is the same as Top-Down for primary and backup server, while the second backup server will

7 KB (1,046 words) - 09:35, 21 May 2024
Timed Signalling and Messaging
As the internal clock of the ICX-AlphaCom server might drift over time, it is Change parameters as required.

5 KB (712 words) - 20:36, 22 July 2022
Mobile App - User Guide
...roid and IOS devices. Zenitel Mobile enables you to use your mobile device as an intercom station in the IC-EDGE system. *Relay operations (by sending a number as DTMF)

5 KB (724 words) - 12:34, 31 May 2023
1-4g. Main Features - Alarm Message Distribution (practice)
...ad of using the standard alarm message, a new customized message available as wav file should be used

721 bytes (107 words) - 14:16, 6 April 2011
1-4j. RCO, Call indication (solution)
[[File:1-4j solution3.PNG|thumb|left|500px|RCO 10 will be turned ON as long as there are calls in the call queue]]

2 KB (355 words) - 10:06, 30 June 2022
Fire Alarm interface via ESPA444
...have an address. Set the address of the exchange and the fire alarm panel as appropriate in AlphaPro, [[Exchange_%26_System_(AlphaPro)#Fire_Alarm|Exchan ...), where the owner is physical station nr 1. The trigger action is defined as 'ON'. The event is related to a directory number. The numbers used are 84xx

3 KB (456 words) - 11:10, 19 November 2019
SET TIMER
A station must be specified as owner of the timer. It is also possible to specify the “related-to” par |colspan="3"|Station to be used as related-to parameter in timeout event. Null value allowed. (Only [[NRF_LOC

2 KB (352 words) - 13:10, 30 June 2022
M-key (Event Type)
* Use the M-key as an additional call key for substations

718 bytes (103 words) - 14:23, 24 May 2022
Pocket Paging in a Hospital
...each medical emergency teams that must physically reach the sender as soon as possible, thus making the name rather than the number more important. Can a ...eed to have many users on a single physical number. If possible it is just as well to use a user with physical number for each "dummy" pager.

8 KB (1,320 words) - 14:46, 31 May 2022
GLOB GRP MEMB
...Each exchange will do this after reset, periodically during operation, and as response to [[BUILD_GLOB_GRP]].

782 bytes (116 words) - 15:58, 3 October 2019

Special

Search results