Vandal Resistant intercom - VR3G-1: Difference between revisions
From Zenitel Wiki
No edit summary |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{ | {{ACEIS}}[[file:VR3G-1 Front.png|thumb|200px|VR3G-1 (1008021010)]] | ||
*3mm (11 gauge) Stainless Steel | *3mm (11 gauge) Stainless Steel | ||
*Stainless steel call button | *Stainless steel call button | ||
* | *Vandal Resistant Design with IK10 | ||
*IP66 - Dirt, dust and water resistant | |||
*Tamper switch | *Tamper switch | ||
*Anti-ligature design | *Anti-ligature design | ||
*For mounting in [[Backbox_3_Gang_-_1008098300|3 gang backbox]]. | |||
==Getting started== | ==Getting started== | ||
*[[Starting Up Turbine Station|Starting up]] | *[[Starting Up Turbine Station|Starting up]] | ||
==Configuration== | ==Configuration== | ||
The | The device can operate in [[Main Settings (IP Stations)|different modes]]. Set the mode according to the server the station should register to. | ||
* [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]] | * [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]] | ||
* [[Adding station to existing system (Edge)|Edge mode]] | * [[Adding station to existing system (Edge)|Edge mode]] | ||
* [[SIP Intercom - Web Interface|SIP mode]] | * [[SIP Intercom - Web Interface|SIP mode]] | ||
{{note|To use this device with [[:Category:Zenitel Connect Pro|Zenitel Connect Pro]] it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.}} | |||
Station specific configuration: | Station specific configuration: | ||
| Line 30: | Line 30: | ||
*[[:Category:IMX28 Release notes|Software Release Notes]] | *[[:Category:IMX28 Release notes|Software Release Notes]] | ||
==Connectors and Dimensions== | ==Connectors, Mounting and Dimensions== | ||
*[[VR3G-1 and VR3G-1P Board Connectors|Board Connections]] | *[[VR3G-1 and VR3G-1P Board Connectors|Board Connections]] | ||
*[[VR3G-1 Dimensions|Dimensions]] | *[[VR3G-1(P) Mounting and Dimensions|Mounting and Dimensions]] | ||
==Accessories== | ==Accessories== | ||
Latest revision as of 16:03, 3 January 2025
- 3mm (11 gauge) Stainless Steel
- Stainless steel call button
- Vandal Resistant Design with IK10
- IP66 - Dirt, dust and water resistant
- Tamper switch
- Anti-ligature design
- For mounting in 3 gang backbox.
Getting started
Configuration
The device can operate in different modes. Set the mode according to the server the station should register to.
|
To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server. |
Station specific configuration:
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors, Mounting and Dimensions
Accessories
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.7