Vandal Resistant intercom - VR3G-1P: Difference between revisions
From Zenitel Wiki
ZenitelAus (talk | contribs) No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
{{ | {{ACEIS}}[[file:VR3G-1P Front.png|thumb|200px|VR3G-1P (1008021015)]] | ||
*3mm (11 gauge) Stainless Steel | *3mm (11 gauge) Stainless Steel | ||
| Line 11: | Line 11: | ||
==Getting started== | ==Getting started== | ||
*[[Starting Up Turbine Station|Starting up]] | *[[Starting Up Turbine Station|Starting up]] | ||
==Configuration== | ==Configuration== | ||
The | The device can operate in [[Main Settings (IP Stations)|different modes]]. Set the mode according to the server the station should register to. | ||
* [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]] | |||
* [[Adding station to existing system (Edge)|Edge mode]] | |||
* [[SIP Intercom - Web Interface|SIP mode]] | |||
*[[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]] | {{note|To use this device with [[:Category:Zenitel Connect Pro|Zenitel Connect Pro]] it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.}} | ||
*[[Adding station to existing system (Edge)|Edge mode]] | |||
*[[SIP Intercom - Web Interface|SIP mode]] | |||
Station specific configuration: | Station specific configuration: | ||
*[[Configuration of the VR3G-1 and VR3G-1P|Configuration of the VR3G-1P]] | *[[Configuration of the VR3G-1 and VR3G-1P|Configuration of the VR3G-1P]] | ||
*[[Self Testing Call Button (ICX-AlphaCom mode)]] | *[[Self Testing Call Button (ICX-AlphaCom mode)]] | ||
Revision as of 16:03, 3 January 2025
- 3mm (11 gauge) Stainless Steel
- Piezo self testing call button
- Vandal Resistant Design with IK10
- IP66 - Dirt, dust and water resistant
- Tamper switch
- Anti-ligature design
- For mounting in 3 gang backbox.
Getting started
Configuration
The device can operate in different modes. Set the mode according to the server the station should register to.
|
To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server. |
Station specific configuration:
Restore Factory Defaults and Software Upgrade
- Due to the Piezo button on this unit, it is not possible to hold down the button as per a regular Turbine device. Therefore, follow the directions for Factory Defaults of the TKIS-2. Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors, Mounting and Dimensions
Accessories
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.7