EINS-1: Difference between revisions
From Zenitel Wiki
(Created page with "{{ACEIS}} 500px|thumb|Intelligent Sensor<br>(1023560500)|alt= ==Getting started== * Starting up ==Configuration== The devi...") |
No edit summary |
||
| Line 1: | Line 1: | ||
{{ACEIS}} | {{ACEIS}} | ||
The EINS-1 consists of a [[TKIS-2|TKIS-2 kit]] and an electret microphone encapsulated in an powder coated aluminum housing with IP-65 grade. The unit is powered by PoE. | |||
Typical use cases are: | |||
* Listen-in microphone | |||
* Ambient noise measurement in relation to [[Distributed Automatic Volume Control (DAVC) (SIP)|Automatic Volume Control DAVC]]. | |||
[[file:Eins-1.png|500px|thumb|Intelligent Sensor<br>(1023560500)|alt=]] | [[file:Eins-1.png|500px|thumb|Intelligent Sensor<br>(1023560500)|alt=]] | ||
==Getting started== | ==Getting started== | ||
Revision as of 10:35, 21 February 2025
The EINS-1 consists of a TKIS-2 kit and an electret microphone encapsulated in an powder coated aluminum housing with IP-65 grade. The unit is powered by PoE.
Typical use cases are:
- Listen-in microphone
- Ambient noise measurement in relation to Automatic Volume Control DAVC.
Getting started
Configuration
The device can operate in different modes. Set the mode according to the server the station should register to.
|
To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server. |
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors, Indicators and Dimensions
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.7