TCIA-2

The TCIA-2 is an IP based intercom with an analog front board intended for areas where exposure of the physical network is unwanted.

The solution is based on a TKIS-2 VoIP kit, where audio and control signals are connected to an interface (TKIA-2), before they are transported to the front unit TCIA-2.

Analog over IP Intercom
(1008113020)

Getting started

• General TKIS connections
• Starting up

Connecting the devices

The 8-wire cable provided is used for connecting the TKIA-2 Gateway to the TKIS-2 Intercom. The colorcoded wires serve as a visual aid to connecting to the correct pins at both ends.

• Using the 8-wire cable, connect the pins on the TKIA-2 to the corresponding pins on the TKIS-2 according to the drawing.

An FTP cable (maximum 60 meters) is used to connect the TKIA-2 Gateway to the TCIA-2 Intercom.

• Using the FTP cable, connect the RJ45 port on the TKIA-2 to the RJ45 port on the TCIA-2.

Configuration

The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.

• ICX-AlphaCom mode
• Edge mode
• SIP mode
• Pulse mode

Station Specific Configuration:

• TCIA-2 Call Button and Station LED

Restore Factory Defaults and Software Upgrade

• Restore Factory Defaults
• Upgrade via the station web interface
• Upgrade using the IMT tool
• Automatic Software Upgrade (SIP mode only)
• Software Release Notes

Connectors, Indicators and Dimensions

• Board Connections
• Station Indication LEDs
• Dimensions

Accessories

• TA-1, Turbine Compact Onwall Box - 1008140010
• TA-2, US 2 GANG, Double Depth - 3.5”, Back Box, Masonry - 1008140020
• TA-5, Bracket for US 2 GANG Back Box - 1008140050
• TA-14 Microphone Windscreen - 1008140140

Software Requirements

This station is fully supported as from AlphaCom version 11.2.3.7