Actions

Difference between revisions of "TFIX-1-V2"

From Zenitel Wiki

(Getting started)
(Connectors, Indicators and Dimensions)
Line 39: Line 39:
  
 
== Connectors, Indicators and Dimensions ==
 
== Connectors, Indicators and Dimensions ==
* [[TFIX-V2 Connections|Board Connections]]
+
* [[TFIX-V2 Connections|Device Connections]]
 
* [[TFIX Indication LEDs|Station Indication LEDs]]
 
* [[TFIX Indication LEDs|Station Indication LEDs]]
 
* [[TFIE Dimensions & Mounting Instructions|Dimensions]]
 
* [[TFIE Dimensions & Mounting Instructions|Dimensions]]

Revision as of 14:21, 23 June 2023

AEIS.png
Warning icon TFIX-1-V2 is supported from software version 6.1.3.0. Do not attempt to downgrade to software below 6.1.3.0!


Turbine Industry - EX
(1008123110)


Highlights

  • Ex IP intercom for potentially explosive atmospheres - Directive 2014/34/EU
  • Ethernet compatible 2-wire interface (FCDC-3)
  • Dust- and water-protected to IP66
  • ONVIF Compatible
  • Visible status indicators on front panel
  • Input power supply 24V-48Vdc SELV approved (48Vdc recommended)
  • Separate amplifier for external loudspeaker (25W/8ohm). 48Vdc input power needed.
  • Signal relay for external beacon (SELV approved power supply needed)
  • 2 freely programmable pot.free inputs


TFIX-V2 Speaker and Beacon


Getting started

Configuration

The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.

Restore Factory Defaults and Software Upgrade

Connectors, Indicators and Dimensions

Accessories


Software and Hardware Requirements

  • This station is fully supported as form AlphaCom version 11.2.3.11
  • Flowire FCDC-3 is required at central location
Note icon FCDC-1 and FCDC-2 are not supported.


Related Information