TFIX-1-V2

Turbine Industry - EX
(1008123110)

Highlights

• Ex IP intercom for potentially explosive atmospheres - Directive 2014/34/EU
• Ethernet compatible 2-wire interface (FCDC-3)
• Dust- and water-protected to IP66
• ONVIF Compatible
• Visible status indicators on front panel
• Input power supply 24V-48Vdc SELV approved (48Vdc recommended)
• Separate amplifier for external loudspeaker (25W/8ohm). 48Vdc input power needed.
• Signal relay for external beacon (SELV approved power supply needed)
• 2 freely programmable pot.free inputs

TFIX-V2 Speaker and Beacon

Getting started

• Starting up
• TFIX Keyboard Settings
• Setting Flowire NMK Password

Configuration

The device can operate in different modes. Set the mode according to the server the station should register to.

• ICX-AlphaCom mode
• Edge mode
• SIP mode

To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.

Restore Factory Defaults and Software Upgrade

• Restore Factory Defaults
• Upgrade via the station web interface
• Upgrade using the IMT tool
• Automatic Software Upgrade (SIP mode only)
• FCDC-3 Software Upgrade Procedure
• Software Release Notes
• Flowire Release notes

Connectors, Indicators and Dimensions

• Device Connections
• Station Indication LEDs
• Dimensions

Accessories

• Headset AK5850HS
• Handset TAX-3 (100 8150 030)
• Handheld microphone EMMAX-1H

Software and Hardware Requirements

• This station is fully supported as form AlphaCom version 11.2.3.11
• Flowire FCDC-3 is required at central location

FCDC-1 and FCDC-2 are not supported. TFIX-1-V2 is supported from software version 6.1.3.0. Do not attempt to downgrade to software below 6.1.3.0!

Related Information

• Flowire FCDC-3
• TFIX V2 - Installation Solutions
• Additional Documentation on Zenitel.com