Search results

Create the page "AS" on this wiki! See also the search results found.

Station ID feature
Note: IP address of Eth0/Eth1 is the ''configured'' IP addresses, as used by Intercom Application (AMCd). The difference is if you use the [[IP

1 KB (175 words) - 09:29, 11 May 2022
COMMAND RESPONSE
...ssage id, see separate descriptions under each message having this message as response.

1 KB (180 words) - 16:13, 6 July 2022
IP DECT Base Repeater Wall
...overage area in a wireless radio synchronization solution, where it serves as a receiver and transmitter in relaying radio signals. Depending on the repe ...he repeater has been powered, sync has still not been established. As soon as sync has been established, the LED is on. Each time a handset connects to t

10 KB (1,455 words) - 16:02, 8 November 2021
Distributed Automatic Volume Control (DAVC) (SIP)
...ublic Address - Network amplifiers|ENA amplifier]], or a PA Interface such as a [[TKIS-2|TKIS-kit]] or [[TKIE-2|TKIE-kit]]. The '''Distributed Automatic Volume Control (DAVC)''' is supported as from Turbine firmware v. 4.11.

6 KB (958 words) - 10:18, 12 June 2024
Occasional blue-screen when opening/closing communication
...down will display COM1 - COM 256 and if they are in use. If COM9 is listed as ''In Use'', you will need to find out which application is using it and con

1 KB (207 words) - 10:58, 24 October 2023
AMAG Symmetry - IC-EDGE Integration
...assumes a single camera, but there are larger camera bundles as well (such as VID-CAM-016-V9 for a block of 16 cameras)}} ...tercom system. The intercoms are normally sited outside the building, such as at doors, parking barriers and other entrances. Typically, the intercoms ar

19 KB (2,901 words) - 14:07, 15 February 2022
Avaya-Nortel CS1000 v. 7.6
...the compliance testing, the Zenitel Stentofon Turbine Intercom was set up as a 3rd Party SIP Extension on Avaya Communication Server 1000E and underwent ...IP Deskphones were configured. Stentofon Turbine is registered to the SLG as a Third Party SIP Client (SIP3). An ISDN-PRI trunk connects the CS1000E to

11 KB (1,465 words) - 11:50, 17 March 2017
ONVIF Settings
*Devices can now send SIP name as hardware model ...as Digital Input in ONVIF''': Call button pressed on a station is reported as Digital Input to a Video Management System.

40 KB (5,470 words) - 17:18, 27 November 2023
Transfer Features
...ffice, you can have your calls re-routed to you. (This is the same feature as Call Forward, but you activate it from the remote station.) You can also make Inquiry Calls to other features such as group calls or paging.

4 KB (604 words) - 14:08, 3 June 2022
GROUP MSG
..."center" |7||[[UINT2]]<br>(optional 11.3)|| colspan="3" |Group Call bitmap as used in the PA features parameters are shown below. Param2 is used as a control bitmap. Also used in Param1 of [[PA activation, multi-step]].

7 KB (937 words) - 10:59, 21 July 2022
IP-ARIO Configuration
...rnet Protocol Properties''' to use an IP address that is in the same range as 169.254.1.100, e.g. 169.254.1.1 with subnet mask 255.255.0.0. IP-ARIO must be configured as a CCoIP station:

10 KB (1,524 words) - 13:08, 21 September 2018
IMT - Discover & Upgrade
...s several Ethernet interfaces, select the one which is on the same network as the Zenitel devices ("'''Choose TFTP server IP address'''") * FCDC3 is supported as from IMT ver. 1.6.3.0

5 KB (767 words) - 11:09, 8 September 2023
Door Opening feature (Pulse)
...door station can be operated by pressing digit "6" on the master station. As the Door Stations by default are configured to trigger on DTMF "6", no spec

1 KB (201 words) - 16:35, 12 September 2019
PAR RING
...rallel Ringer station]] to a call in ringing state. Most useful to be used as an Event Handler action in [[Private_Ringing_mode_%28Event_Type%29]].

1 KB (191 words) - 12:47, 30 June 2022
AlphaCom Audio Switching Hardware
...uch as Slave Controllers are not shown. That the Master board also doubles as a Audio short. Audio travels through the system as 1Mbit/s line-switched digital signals. The backplane has 16

12 KB (1,902 words) - 14:24, 5 February 2018
AlphaPro 12 - Error messages
...Stations" licenses installed (which is the case when the AlphaCom is used as a Secondary server in a [[Redundant Servers (AlphaCom XE)|redundant system]

1 KB (190 words) - 10:53, 24 October 2023
ENA Amplifier - Mounting and Installation
...tus indicators are used to display the status of important parameters such as power supplies and faults ...elay (NO, NC & COM) kept in the active position between COM and NO as long as no faults are present in the device

9 KB (1,437 words) - 13:56, 13 June 2024
Turbine Test and Demo Application
...nstallation package includes the Turbine Test and Demo Application as well as a PC-tool for image upgrade of the AMC-IP board. ...to take effect. '''Note!''' Make sure these ports are open in your laptop as well.

9 KB (1,376 words) - 16:13, 17 June 2024
Free Seating
16 => Directory number 1 is defined as local (Feature 9) in several nodes 17 => Directory number 2 is defined as local (Feature 9) in several nodes

8 KB (1,173 words) - 11:31, 1 June 2022
STIC
...ing operation the IP configuration and licenses will be stored on the STIC as well. This makes it possible to replace the AMC-IP easily without having to {{warn|STIC's delivered from Zenitel as from 2020: Firmware version AMC 13.1.3.6 or later is required .}}

8 KB (1,431 words) - 13:45, 7 September 2021

Special

Search results