Difference between revisions of "ECPIR-3P"
From Zenitel Wiki
(→Connectors, Indicators and Dimensions) |
(→Connectors, Indicators and Dimensions) |
||
| Line 25: | Line 25: | ||
==Connectors, Indicators and Dimensions== | ==Connectors, Indicators and Dimensions== | ||
| − | + | * [[Turbine Extended series board connectors|Device Connections]] | |
| − | *[[Turbine Extended | + | * [[TFIE Indication LEDs|Station Indication LEDs]] |
| − | *[[TFIE Indication LEDs|Station Indication LEDs]] | + | * [[ECPIR Dimensions & Mounting Instructions|Dimensions]] |
| − | *[[ECPIR Dimensions & Mounting Instructions|Dimensions]] | ||
==Accessories== | ==Accessories== | ||
Revision as of 11:54, 23 June 2023
Contents
Getting started
Configuration
The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
General configuration:
Station specific configuration for the ECPIR:
- Configuration for Expansion Module EBMDB-8
- Direct Access Key & Ringlist Settings (Edge)
- Direct Access Key & Ringlist Settings (SIP)
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors, Indicators and Dimensions
Accessories
| 100px | 
|
|
|
|
| EBMDR-8 | MB-30G | PAM1H | EMBR-1 | EMBR-2 |
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.11
- Edge mode is supported from firmware version 5.0
- SIP (and Pulse) mode is fully supported as from firmware version 4.7