TFIX-1-V2: Difference between revisions
From Zenitel Wiki
No edit summary |
|||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{ | {{ACEIS}} | ||
[[file:TFIX-1-newZ.png|thumb|400px|Turbine Industry - EX<br>(1008123110)]] | [[file:TFIX-1-newZ.png|thumb|400px|Turbine Industry - EX<br>(1008123110)]] | ||
==Highlights== | ==Highlights== | ||
* Ex IP intercom for potentially explosive atmospheres - Directive 2014/34/EU | * Ex IP intercom for potentially explosive atmospheres - Directive 2014/34/EU | ||
| Line 24: | Line 22: | ||
==Configuration== | ==Configuration== | ||
The | The device can operate in [[Main Settings (IP Stations)|different modes]]. Set the mode according to the server the station should register to. | ||
* [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]] | * [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]] | ||
* [[Adding station to existing system (Edge)|Edge mode]] | * [[Adding station to existing system (Edge)|Edge mode]] | ||
* [[SIP Intercom - Web Interface|SIP mode]] | * [[SIP Intercom - Web Interface|SIP mode]] | ||
{{note|To use this device with [[:Category:Zenitel Connect Pro|Zenitel Connect Pro]] it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.}} | |||
== Restore Factory Defaults and Software Upgrade == | == Restore Factory Defaults and Software Upgrade == | ||
| Line 55: | Line 53: | ||
{{note| | {{note| | ||
* ''FCDC-1 and FCDC-2 are | * ''FCDC-1 and FCDC-2 are not supported. <br> | ||
* ''TFIX-1-V2 is supported from software version 6.1.3.0. Do not attempt to downgrade to software below 6.1.3.0!}} | * ''TFIX-1-V2 is supported from software version 6.1.3.0. Do not attempt to downgrade to software below 6.1.3.0!}} | ||
Revision as of 16:13, 3 January 2025
Highlights
- Ex IP intercom for potentially explosive atmospheres - Directive 2014/34/EU
- Ethernet compatible 2-wire interface (FCDC-3)
- Dust- and water-protected to IP66
- ONVIF Compatible
- Visible status indicators on front panel
- Input power supply 24V-48Vdc SELV approved (48Vdc recommended)
- Separate amplifier for external loudspeaker (25W/8ohm). 48Vdc input power needed.
- Signal relay for external beacon (SELV approved power supply needed)
- 2 freely programmable pot.free inputs
Getting started
Configuration
The device can operate in different modes. Set the mode according to the server the station should register to.
|
To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server. |
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- FCDC-3 Software Upgrade Procedure
- Software Release Notes
- Flowire Release notes
Connectors, Indicators and Dimensions
Accessories
Software and Hardware Requirements
- This station is fully supported as form AlphaCom version 11.2.3.11
- Flowire FCDC-3 is required at central location
|
|
|