TFIX-1-V2: Difference between revisions

Latest revision as of 14:22, 27 November 2025

Turbine Industry - EX
(1008123110)

Ex IP intercom for potentially explosive atmospheres - Directive 2014/34/EU
Ethernet compatible 2-wire interface (FCDC-3)
Dust- and water-protected to IP66
ONVIF Compatible
Visible status indicators on front panel
Input power supply 24V-48Vdc SELV approved (48Vdc recommended)
Separate amplifier for external loudspeaker (25W/8ohm). 48Vdc input power needed.
Signal relay for external beacon (SELV approved power supply needed)
2 freely programmable pot.free inputs

TFIX-V2 Beacon and External Speaker (ext. speaker works in parallel with internal speaker)

The device can operate in different modes. Set the mode according to the server the station should register to.

To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.

FCDC-1 and FCDC-2 are not supported.
TFIX-1-V2 is supported from software version 6.1.3.0. Do not attempt to downgrade to software below 6.1.3.0!

@@ Line 1: / Line 1: @@
-{{AEIS}}{{warn|TFIX-1-V2 is supported from software version 6.1.3.0. Do not attempt to downgrade to software below 6.1.3.0!}}[[file:TFIX1Front.PNG|thumb|400px|Turbine Industry - EX<br>(1008123110)]]
+{{ACEIS}}
+[[file:TFIX-1-newZ.png|thumb|400px|Turbine Industry - EX<br>(1008123110)]]
 ==Highlights==
 * Ex IP intercom for potentially explosive atmospheres - Directive 2014/34/EU
@@ Line 14: / Line 13: @@
-[[file:TFIX-V2 Speaker and Beacon.png|thumb|left|500px|TFIX-V2 Speaker and Beacon]]
+[[file:TFIX-V2 Speaker and Beacon.png|thumb|left|500px|TFIX-V2 Beacon and External Speaker (ext. speaker works in parallel with internal speaker)]]
 <br style="clear:both;" />
@@ Line 23: / Line 22: @@
 ==Configuration==
-The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
+The device can operate in [[Main Settings (IP Stations)|different modes]]. Set the mode according to the server the station should register to.
 * [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]]
 * [[Adding station to existing system (Edge)|Edge mode]]
 * [[SIP Intercom - Web Interface|SIP mode]]
+{{note|To use this device with [[:Category:Zenitel Connect Pro|Zenitel Connect Pro]] it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.}}
 == Restore Factory Defaults and Software Upgrade ==