Vandal Resistant intercom - VR3G-1P
From Zenitel Wiki
- 3mm (11 gauge) Stainless Steel
- Piezo self testing call button
- Vandal Resistant Design with IK10
- IP66 - Dirt, dust and water resistant
- Tamper switch
- Anti-ligature design
- For mounting in 3 gang backbox.
Getting started
Configuration
The device can operate in different modes. Set the mode according to the server the station should register to.
|
To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server. |
Station specific configuration: Configuration of the VR3G-1P
Button Test
The VR3G-1P intercom features a Self Testing Call Button.
- Self Testing Call Button when VR3G-1P is used with ICX-AlphaCom
- Self Testing Call Button when VR3G-1P is used with Zenitel Connect Pro
Restore Factory Defaults and Software Upgrade
- Due to the Piezo button on this unit, it is not possible to hold down the button as per a regular Turbine device. Therefore, follow the directions for Factory Defaults of the TKIS-2. Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors, Mounting and Dimensions
Accessories
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.7