ECPIR-3P: Difference between revisions

Latest revision as of 16:10, 3 January 2025

Exigo call panel (1023200033)

The device can operate in different modes. Set the mode according to the server the station should register to.

To use this device with Zenitel Connect Pro it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.

Station specific configuration for the ECPIR:


EBMDR-8	MB-30G	PAM1H	EMBR-1	EMBR-2

This station is fully supported as from AlphaCom version 11.2.3.11

@@ Line 1: / Line 1: @@
-{{AEIPS}}[[file:ECPIR-3P-newZ.png|200px|thumb|Exigo call panel (1023200033)|alt=]]
+{{ACEIS}}[[file:ECPIR-3P-newZ.png|200px|thumb|Exigo call panel (1023200033)|alt=]]
 ==Getting started==
 * [[Starting Up Turbine Station|Starting up]]
 ==Configuration==
-The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
+The device can operate in [[Main Settings (IP Stations)|different modes]]. Set the mode according to the server the station should register to.
-General configuration:
 * [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]]
 * [[Adding station to existing system (Edge)|Edge mode]]
 * [[SIP Intercom - Web Interface|SIP mode]]
+{{note|To use this device with [[:Category:Zenitel Connect Pro|Zenitel Connect Pro]] it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.}}
 Station specific configuration for the ECPIR: