ACDP messages
From Zenitel Wiki
AlphaCom data protocol messages.
Pages in category "ACDP messages"
The following 200 pages are in this category, out of 206 total.
(previous page) (next page)A
- ABSENCE STATUS
- ALARM MSG
- ALARM MSG ACK
- AlphaNet Data Protocol
- AUDIO CH DISCON
- AUDIO CH FAULTY
- AUDIO CH LOOPBACK ACK
- AUDIO CH LOOPBACK REQ
- AUDIO CH TONE REQ
- AUDIO CODEC
- AUDIO DETECT
- AUDIO LINK NOT AVAILABLE
- AUDIO LINK OK
- AUDIO LINK RELEASE
- AUDIO M FEED REQ
- AUDIO M FEED STOP
- AUDIO M LINK OK
- AUDIO M PATH BACKTRACK
- AUDIO M PATH OK
- AUDIO M PATH SETUP
- AUDIO PATH CHECK OK
- AUDIO PATH DELAY
- AUDIO PATH DISCONNECT
- AUDIO PATH OK
- AUDIO PATH SETUP
- AUDIO PATH STATE
- AUDIO RTP DTMF DIGIT
- AUDIO RTP DTMF SETUP
C
- C KEY
- CALL SETUP
- CALL STATUS BC
- CALL TRANSFER
- CALL TRANSFER NOK
- CALL TRANSFER OK
- CANCEL ALL CALLS
- CANCEL MAIL
- R KEY
- SYNC FLASH
- CDC CMD
- CDC STATE
- CFG UPD
- CHECK AUDIO PATH
- CHILLY RESET
- CLEAR RCO
- CLEAR RCO FAILED
- CLEAR RCO OK
- COMMAND RESPONSE
- CONF IS ROOT
- CONF JOIN
- CONF MEMB CHK
- CONF NOT ROOT
- CONF ORD MEMB
- CONF TALK
- CONF TALK STOP
- CONN 2 GROUP
- CONN REF ACK
- CONN REFERENCE
- CONN REQUEST
- CONN STATUS BC
- CONSOLE DISC
- CONSOLE REQ
- COPY MAIL
D
G
M
P
R
S
- SCAN END ACK
- SCAN RCI ACK
- SCAN RCI ONCE
- SEND MAIL
- SEND MAIL ACK
- SEND TXT MAIL
- SET ABSENCE
- SET CALL REQ MODE
- SET DIRNO TXT
- SET GRP FILT
- SET IPRCO
- SET LOGICAL RCO
- SET MAIL TIMEOUT
- SET NODE NUMBER
- SET RCO
- SET RCO FAILED
- SET RCO OK
- SET REQ TRANSF
- SET STATION COS
- SET SYSTEM TIME
- SET TIMER
- SILENT CALL
- SIMP (SET SIMPLEX)
- SINGLE DIGIT
- SMALL RESET
- SNV
- ST AUDIO OPT
- ST BUSY BC
- ST FREE BC
- ST GROUP DISCON
- ST STATE
- STATION BUSY
- STATION CONVERSATION
- STATION DOWN
- STATION EVENT BLOCK
- STATION INFO
- STATION LISTEN
- STATION TRANSFER
- STATUS REPORT
- SVP ST
- SYSPARAM
- SYSTEM TIME