Search results
Create the page "Note" on this wiki! See also the search results found.
- # Do a "Clean & Factory Reset" from the web interface. Note that licenses are deleted so you need to insert them again {{Note| During this procedure any license will be deleted so you need to insert th503 bytes (73 words) - 14:16, 8 October 2019
- {{note| {{note| AlphaPro v12 is also supported using Windows 11}}930 bytes (133 words) - 15:53, 4 April 2024
- '''Note 1:''' Block state will always be cleared after reset. <br> '''Note 2:''' Only station events kicked by DIP protocoll are blocked. Events from1 KB (214 words) - 16:11, 3 October 2019
- {{Note|If there are uploaded messages, download and store these.}} {{Note|Upload audio messages if any}}856 bytes (121 words) - 10:19, 25 September 2020
- {{note|If PoE is used, the station must be installed using a shielded Ethernet cab {{note|If an external power supply is being used, please make sure the power suppl3 KB (424 words) - 15:43, 8 September 2023
- {{Note|AMC 9: The script uses approx. 3 seconds to empty a group of 100 members. 1 {{Note|AMC 11: The script uses approx. 2 seconds to empty a group of 552 members}}873 bytes (122 words) - 11:35, 8 July 2022
- ''Note: A change of the IP address is made via the web interface of the CP-CAM.'' # Note the switch position and then turn both switches to "OFF".959 bytes (156 words) - 15:10, 5 February 2018
- Note the limitation of the Total Recall recorder are Mono recordings in g.711u o Note that the expected logging of the calls is by the Display Name only. Ensure1 KB (176 words) - 03:50, 4 May 2023
- '''NOTE: Since AlphaPro version 11.5.x.x there is no support for serial communicati302 bytes (45 words) - 10:59, 24 October 2023
- {{note|Triggered only when the mail is received, i.e. "When Change To" goes ON }}326 bytes (48 words) - 09:46, 4 October 2019
- {{note|Triggered only when the mail is received, i.e. "When Change To" goes ON }}333 bytes (48 words) - 09:46, 4 October 2019
- {{note|This article is applicable for the [[School IP Intercom - 1402001000]].}} {{Note| This LED behaviour only applies in ICX-AlphaCom mode}}1 KB (168 words) - 17:25, 31 January 2023
- == Note template == <nowiki>{{Note|Lorem ipsum dolor sit amet, consetetur sadipscing elitr, sed. }}</nowiki>4 KB (614 words) - 14:06, 13 September 2019
- *789 + M + M + M: Show IP address of Eth0 and Eth1 (see note below) Note: IP address of Eth0/Eth1 is the ''configured'' IP addresses, as used by Int1 KB (175 words) - 09:29, 11 May 2022
- {{note|[[Advanced Configuration Mode (Edge)|Advanced Configuration Mode]] must be {{Note|VoIP port range is configurable from firmware 2.7 (INCA) and 4.7 (Turbine)2 KB (191 words) - 16:22, 12 September 2023
- {{Note|This option is available for the [[IP Desk Master -V2 w/handset|IP Desk Mas {{Note|To access the '''Language''' settings, you must enable [[Advanced Configura1 KB (212 words) - 12:06, 19 May 2021
- {{Note|This option is available for the [[IP Desk Master -V2 w/handset|IP Desk Mas {{Note|To access the '''Language''' settings, you must enable [[Advanced Configura1 KB (210 words) - 12:00, 19 May 2021
- The AlphaCom requires the presence of the appropriate API/OPC license. Note that every AlphaCom in an AlphaNet requires such a license. ...llation instructions for [[OPC Classic for AlphaCom - Installation]]{{Note|Note: At this time, there is a buffer overflow bug in SiPass that will crash the2 KB (310 words) - 09:01, 16 August 2022
- {{note|This is not a 1:1 cable }}423 bytes (57 words) - 09:15, 29 September 2021
- ** Note that in software AMC 11.2.3.9 or earlier the inputs were reported as DAK 1 ** Note that in software AMC 11.2.3.9 or earlier the outputs were numbered 1 - 7. I3 KB (461 words) - 11:21, 23 June 2023
- {{note|This article is applicable for the [[School IP Intercom - 1402001000]].}} '''Note:''' The off-line display menu is not available for the School IP Intercom,2 KB (312 words) - 17:25, 31 January 2023
- {{note|This article is applicable for the [[School IP Intercom - 1402001000]].}} '''Note:''' The off-line display menu is not available for the School IP Intercom,2 KB (309 words) - 17:24, 31 January 2023
- {{note|This article is applicable for the [[School IP Intercom - 1402001000]].}} '''Note:''' The off-line display menu is not available for the School IP Intercom,2 KB (313 words) - 17:25, 31 January 2023
- {{Note| {{Note|2 KB (255 words) - 14:22, 20 October 2023
- * Note that the address can be different in different AMC software versions.407 bytes (60 words) - 09:47, 4 October 2019
- ...e "your call is registered, please wait", then ring/flashing at a station. Note that the station leaves this mode if becomes busy for some reason (dialing, ...ustom Voice message for call request as parameter. Format N!!<message id>. Note : L<dirno> (e.g. L8194) is not supported.2 KB (229 words) - 16:07, 3 October 2019
- Note that in expression '''@<node>''' the "node" is the hexadecimal value of the507 bytes (77 words) - 16:48, 24 May 2022
- {{Note|'''Note on [[:Category:Stations#Turbine_stations|TFIX station]]''':1 KB (219 words) - 13:45, 20 January 2021
- == Important note on Turbine Stations ==2 KB (292 words) - 14:25, 24 May 2022
- {{Note|For mass upgrade of stations it is recommended to use the [[IMT|VS-IMT]] to {{Note|Turbine IP Master Stations have 2 partitions. The upgrade will be done on t2 KB (253 words) - 09:57, 16 August 2022
- ...define a "Tile View pane", which is where the video will be shown. Make a note of the "Tile ID". <td style='background-color:#efefef;'>Script to start viewing video. Note that the digit (here "0") must match the "Tile ID" of the Tile View pane</t4 KB (574 words) - 10:54, 29 June 2023
- Please note that this is the minimum configuration to get a Turbine station successfull '''Note!'''4 KB (650 words) - 15:30, 13 March 2018
- {{Note| There is no polarity requirement on the power input when using either 24vA ...s, connecting the line output of the IP station to the input of amplifier. Note that when used with IP stations the output power will be less than specifie1 KB (215 words) - 13:27, 5 July 2022
- Please note that this is the minimum configuration to get a Turbine station successfull '''Note!'''4 KB (650 words) - 16:34, 16 June 2023
- {{Note|In VS-IS 4.7 default FACTORY gain values in XML are set to -6 dB which will500 bytes (75 words) - 14:42, 3 March 2022
- ...NN_REQUEST]]: The AlphaCom acknowledges the [[DISC_REQ]] message. <BR\>- Note that the message header <reference> is identical to the <reference> used in634 bytes (81 words) - 15:53, 3 October 2019
- '''NOTE:''' This feature number is no longer in use. It was used for the old analog628 bytes (89 words) - 09:41, 8 October 2019
- This release note describes the changes made to the Milestone XProtect AddToLogServerService_697 bytes (92 words) - 10:18, 30 June 2022
- {{Note|This feature number is no longer in use. It was used for the old analog Mul555 bytes (70 words) - 11:00, 8 October 2019
- Please note that PROGRAM_ACK is returned even if the program is not present in AlphaCom584 bytes (77 words) - 16:03, 3 October 2019
- ...FIX Connections|terminal block]] according to the pin configuration below. Note that the black (shield) wire is labeled '''MIC-''' and the black (main shie ...Plugbox cable to the connectors according to the pin configuration below. Note that the black (shield) wire is labeled '''MIC-''' and the black (main shie1 KB (221 words) - 10:24, 28 March 2022
- * Select '''Test''' (7), then '''OK''' (8) to save. (Note that if pressing "OK" without having done "Test" first, the script will not * Select '''Test''' (4), then '''OK''' (5) to save. (Note that if pressing "OK" without having done "Test" first, the script will not5 KB (668 words) - 10:54, 29 June 2023
- {{Note|ZAP configuration is currently only needed if [[VS-IMT VS-SDK for Pulse Sys ...ckup file will be ignored because station will force/generate a new value. Note that most of these settings are not configurable and have specific value on2 KB (247 words) - 12:06, 5 October 2023
- {{note|Depending on which configuration has been changed, it might be neccessary t {{note|Depending on which configuration has been changed, it might be neccessary t3 KB (524 words) - 11:40, 25 March 2020
- {{Note| {{Note|2 KB (211 words) - 15:26, 7 September 2023
- **Ubuntu 18.04.x LTS Server for ICX-AlphaCom version 1.2.3.8 and earlier - note that there is no support for Ubuntu 18.04 anymore {{Note|The virtual machine must have an internet connection and valid DNS server d5 KB (759 words) - 13:54, 13 May 2024
- {{Note|The log file is created every time Wacs (the communication program) runs, w603 bytes (97 words) - 10:54, 24 October 2023
- |colspan="5"|Order station to press C key. Note: C-key has no key-press/key-release operation.620 bytes (82 words) - 12:48, 30 June 2022
- '''NOTE! The gasket MUST be mounted to seal the station!''' '''Note!''' It is recommended to utilize back boxes with weep holes at the bottom3 KB (476 words) - 07:51, 18 October 2016
- ...ber of output and input pins and support for non mandatory features. <br />Note: [[AlphaCom]] [[AMC]] will return 138 outputs and 0 inputs, even if 6 inpu660 bytes (87 words) - 15:57, 3 October 2019